onyx_ptp_interface – Configures PTP on interface

New in version 2.8.

Synopsis
Parameters
Notes
Examples
Return Values
Status

Synopsis

This module provides declarative management of PTP interfaces configuration on Mellanox ONYX network devices.

Parameters

Parameter	Choices/Defaults	Comments
announce_interval -		configure PTP announce setting for interval, Range -3-1
announce_timeout -		configure PTP announce setting for timeout, Range 2-10
delay_request -		configure PTP delay request interval, Range 0-5
name - / required		ethernet or vlan interface name that we want to configure PTP on it
state -	enabled ← disabled	Enable/Disable PTP on Interface
sync_interval -		configure PTP sync interval, Range -7--1

Notes

Note

Tested on ONYX 3.6.8130
PTP Protocol must be enabled on switch.
Interface must not be a switch port interface.

Examples

- name: configure PTP interface
  onyx_ptp_interface:
    state: enabled
    name: Eth1/1
    delay_request: 0
    announce_interval: -2
    announce_timeout: 3

Return Values

Common return values are documented here, the following are the fields unique to this module:

Key	Returned	Description
commands list	always	The list of configuration mode commands to send to the device. Sample: ['interface ethernet 1/16 ptp enable', 'interface ethernet 1/16 ptp delay-req interval 0', 'interface ethernet 1/16 ptp announce interval -1']

Status

This module is not guaranteed to have a backwards compatible interface. [preview]
This module is maintained by the Ansible Community. [community]

Authors

Anas Badaha (@anasb)

Hint

If you notice any issues in this documentation, you can edit this document to improve it.

© 2012–2018 Michael DeHaan
© 2018–2019 Red Hat, Inc.
Licensed under the GNU General Public License version 3.
https://docs.ansible.com/ansible/2.9/modules/onyx_ptp_interface_module.html