Rather than deleting a breakpoint, watchpoint, or catchpoint, you might prefer to disable it. This makes the breakpoint inoperative as if it had been deleted, but remembers the information on the breakpoint so that you can enable it again later.
You disable and enable breakpoints, watchpoints, and catchpoints with
disable commands, optionally specifying
one or more breakpoint numbers as arguments. Use
info break to
print a list of all breakpoints, watchpoints, and catchpoints if you
do not know which numbers to use.
Disabling and enabling a breakpoint that has multiple locations affects all of its locations.
A breakpoint, watchpoint, or catchpoint can have any of several different states of enablement:
breakcommand starts out in this state.
tbreakcommand starts out in this state.
You can use the following commands to enable or disable breakpoints, watchpoints, and catchpoints:
disable [breakpoints] [list…]
Disable the specified breakpoints—or all breakpoints, if none are
listed. A disabled breakpoint has no effect but is not forgotten. All
options such as ignore-counts, conditions and commands are remembered in
case the breakpoint is enabled again later. You may abbreviate
enable [breakpoints] [list…]
Enable the specified breakpoints (or all defined breakpoints). They become effective once again in stopping your program.
enable [breakpoints] once list…
Enable the specified breakpoints temporarily. GDB disables any of these breakpoints immediately after stopping your program.
enable [breakpoints] count count list…
Enable the specified breakpoints temporarily. GDB records
count with each of the specified breakpoints, and decrements a
breakpoint’s count when it is hit. When any count reaches 0,
GDB disables that breakpoint. If a breakpoint has an ignore
count (see Break Conditions), that will be
decremented to 0 before
count is affected.
enable [breakpoints] delete list…
Enable the specified breakpoints to work once, then die. GDB
deletes any of these breakpoints as soon as your program stops there.
Breakpoints set by the
tbreak command start out in this state.
Except for a breakpoint set with
tbreak (see Setting Breakpoints), breakpoints that you set are initially enabled;
subsequently, they become disabled or enabled only when you use one of
the commands above. (The command
until can set and delete a
breakpoint of its own, but it does not change the state of your other
breakpoints; see Continuing and